Vintage Sears Garden Tractors
Would you like to react to this message? Create an account in a few clicks or log in to continue.

Need steps to replace drive pulley on transaxle

Go down

Need steps to replace drive pulley on transaxle Empty Need steps to replace drive pulley on transaxle

Post  davidderouchey January 25th 2009, 5:35 pm

What are the best steps to go about replacing the pulley on the transaxle? Mine has broken loose.
Need to lower the transaxle several inches to get the pulley off, and the replacement one on.
Thanks

davidderouchey

Number of posts : 27
Registration date : 2009-01-12

Back to top Go down

Need steps to replace drive pulley on transaxle Empty pully

Post  hdmcguy February 13th 2009, 9:38 am

better to drop transaxel all the way out some times a puller is required

hdmcguy
Guest


Back to top Go down

Need steps to replace drive pulley on transaxle Empty transaxle pulley replacement

Post  guest March 16th 2009, 10:41 pm

Exactly...needed puller to get old hub off.
Remove to bolts on top, and 2 on each side of frame into transaxle. Also loosen various other rods and whatever attached with transaxle to frame.
Dave

guest
Guest


Back to top Go down

Need steps to replace drive pulley on transaxle Empty Re: Need steps to replace drive pulley on transaxle

Post  Sponsored content


Sponsored content


Back to top Go down

Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum